Mic Archive
Audio-Technica PRO 35
Photo: Audio-Technica, from its spec sheet, p. 1.

Audio-Technica

Audio-Technica PRO 35

Miniature cardioid condenser clip-on for horns, strings and drums, in the UniMount foam-lined clip with a flexible arm; AT8538 power module with 80 Hz roll-off

Type
Condenser (electret)
Pattern
Cardioid
Sensitivity
−45 dBV/Pa
Self-noise
30 dB(A) computed
Max SPL
145 dB SPL
Impedance
250 Ω
Rated range
50 – 15k Hz

Frequency response

Angle
Distance

Frequency response: from the spec sheet, p. 1. "Frequency Response", "12" or more on axis" (about 30 cm). No dB labels: scaled from the "10 dB" bar and set to 0 dB at 1 kHz. Room and smoothing not stated.

Dashed: outside the rated range, or simulated (other angles and distances). Hover or tap the graphs for values.

Polar pattern

Polar pattern: from the spec sheet, p. 1. "Polar Pattern", full circle, 0° up; "SCALE IS 5 DECIBELS PER DIVISION". Measuring conditions not stated.

Compare with other mics

All specs

From the spec sheet
Sensitivity−45 dBV/Pa (5.6 mV/Pa), open circuit, 1 kHz. "–45 dB (5.6 mV) re 1V at 1 Pa".p. 1
Self-noise30 dB(A). Not stated; 94 dB SPL minus the 64 dB signal-to-noise ratio.
Max SPL145 dB SPL, 1 kHz, 1% THD
Signal-to-noise ratio64 dB, 1 kHz at 1 Pa, A-weighted, typical; also 62 dB, "62 dB or more" (Japanese manual). "64 dB, 1 kHz at 1 Pa"; footnote "Typical, A-weighted, using Audio Precision System One". The Japanese manual: "62dB以上".
Dynamic range115 dB, 1 kHz at max SPL, typical
Output impedance250 ohm, balanced
Rated frequency range50 Hz to 15 kHz; also [50, 18000], Japanese manual (2024). The Japanese manual: "50~18,000Hz".
Poweringphantom 11-52 V DC. "11-52V DC, 2 mA typical".
Current draw2 mA, typical
Low cutflat, roll-off; 80 Hz; 18 dB/octave. "80 Hz, 18 dB/octave"; switch on the AT8538 power module: "Flat, roll-off".
ConnectorXLR-3 male on the AT8538 power module; TA3F on the mic cable. "Integral 3-pin XLRM-type" (power module); cable "with TA3F-type connector". The submittal: it plugs into "a TB3M-type jack on the included power module" (page 1).
Weight8 g, microphone, without cable. "Microphone 0.3 oz (8 g)"; power module 81 g.
Dimensions25 × 10.2 mm. Microphone: length × diameter. Power module: 92.9 mm long, 18.9 mm diameter.
Supplied accessoriesAT8418 UniMount instrument mount; AT8538 power module; soft protective pouch
Cable1.8 m (6 ft), permanently attached, 2.6 mm diameter, 2-conductor shielded, TA3F-type connector
OutputLow impedance balanced, pin 2 hot
Operating conditionsAvoid long periods above 43 °C (110 °F) and very high humidity
From the submittal
Finishlow-reflectance black. "a rugged housing with a low-reflectance black finish".p. 1
ModelsPRO 35: with the AT8538 power module (XLR). PRO 35cW: wireless version, 1.4 m (55") cable with a locking 4-pin connector for Audio-Technica UniPak bodypacks, no power module; same dimensions, pattern and mount
MountAT8418 UniMount: foam all round the mic (isolation, protection, windscreen), flexible arm, cable strain relief, rubber-grip spring clamp
Acceptance angleuniform 120°
Audio-Technica case styleM12p. 2

Documents

Copies kept by Mic Archive, because manufacturers move and drop their documents. Each is © Audio-Technica, unchanged, with its original address.

Other mics