Mic Archive
Electro-Voice RE20
Photo: Electro-Voice, from its spec sheet, p. 1.

Electro-Voice

Electro-Voice RE20

Large dynamic cardioid (Variable-D) for broadcast and voice-over, also kick drum and acoustic guitar

Type
Dynamic
Pattern
Cardioid
Sensitivity
−56.5 dBV/Pa computed
Impedance
150 Ω
Rated range
45 – 18k Hz

Frequency response

Angle
Distance

Frequency response: from the spec sheet, p. 2. Titled "Frequency Response"; relative dB, 5 dB per division, no 0 dB marked. Distance and room not stated.

Independent measurement: also drawn, from the Multi-Angle, Multi-Distance Microphone Impulse Response Dataset (Juan Carlos Franco Hernández, Bogdan Bacila, Tim Brookes, Enzo De Sena, University of Surrey) (CC BY 4.0): one unit, measured at 1.25 m and set to 0 dB at 1 kHz, from 136 Hz up. Not the manufacturer's curve.

Dashed: outside the rated range, or simulated (other angles and distances). Hover or tap the graphs for values.

Compare with other mics

All specs

From the spec sheet
CapsuleLarge Acoustalloy diaphragm, low-mass aluminium voice coil; dual-ported Variable-D (continuously variable distance, little proximity effect)p. 1
Sensitivity−56.5 dBV/Pa (1.5 mV/Pa), open circuit voltage, 1 kHz. Not stated by the manufacturer: Stated as 1.5 mV/pascal; converted: 20·log10(0.0015) = -56.5.
Output impedance150 ohm, balanced
Rated frequency range45 Hz to 18 kHz. Down 3 dB at 45 Hz and at 18 kHz (p. 2).
Switchesbass tilt: off, on. "Shall tilt down 4.5 dB from 400-100 Hz" when on. From the "Architects' and Engineers' Specifications" (p. 2).p. 2
ConnectorXLR-3 male. Not stated by the manufacturer: Not named; the wiring diagram shows three pins (pin 2 positive, p. 1).
Weight737 g, netp. 1
Dimensions54.4 × 216.7 mm. Widest diameter × length; body diameter 49.2 mm.
Finishfawn beige; steel case
Supplied accessories81715 stand clamp
Hum pickup-130 dBm typical (60 Hz, 1 millioersted field); hum-bucking coil
Response (flat)Essentially flat from 80 to 6,000 Hz, a broad 2.5 dB rise at 6 to 14 kHz, about 3 dB down at 18 kHz and at 45 Hzp. 2
Rear rejectionMore than 15 dB at 180° from 45 to 10,000 Hz; more than 13 dB above 10 kHz
Blast filterIntegral blast and wind filter, also a shock mount for the elementp. 1

Documents

Copies kept by Mic Archive, because manufacturers move and drop their documents. Each is © Electro-Voice, unchanged, with its original address.

Recommended for

Instruments whose sources name this mic, or an earlier version or variant of it.

Other mics