Mic Archive
Schoeps MK 5
Photo: Schoeps, from its manual, p. 17.

Schoeps

Schoeps MK 5

Small-diaphragm condenser capsule, switchable omni/cardioid (Colette series), on a CMC 6 amplifier

Approximate Some readings for this mic are uncertain; see the graphs.

Type
Condenser
Pattern
Omni / cardioid
Sensitivity
−37.7 dBV/Pa computed
Self-noise
16 dB(A)
Max SPL
132 dB SPL
Impedance
35 Ω
Rated range
40 – 20k Hz

Frequency response

Angle
Distance

Frequency response: from the manual, p. 17. Capsule on a CMC 6 amplifier ("+ CMC 6"), as printed. Free field, distance and smoothing not stated; the sheet draws a tolerance band (dashed) around the curve.

Dashed: outside the rated range, or simulated (other angles and distances). Hover or tap the graphs for values.

Polar pattern

Polar pattern: from the manual, p. 12. Rings every 5 dB, labelled 0 to 25 dB down; 0° at the top. Left half: up to 1 kHz and 2 kHz; right half: 4, 8 and 16 kHz (outer to inner). Measuring conditions not stated. Approximate reading error up to about 1.5 dB; some frequencies are identified by reasoning, not by the legend: 125 Hz, 250 Hz, 500 Hz, 1k Hz, 2k Hz, 4k Hz, 8k Hz, 16k Hz.

Compare with other mics

All specs

From the manual
CapsuleSmall-diaphragm, single diaphragm, mechanically switchable (Colette MK series). "a pure pressure transducer when in the omni setting".p. 17
Sensitivity−37.7 dBV/Pa (13 mV/Pa), cardioid; also −39.2 dBV/Pa, omni. Not stated by the manufacturer: From 13 and 11 mV/Pa: 20·log10(mV/1000).p. 20
Self-noise16 dB(A), cardioid; also 14 dB(A), omni. Specifications for the complete microphone: capsule on a CMC 6 amplifier (p. 20).
Self-noise (CCIR 468)25 dB, cardioid, CCIR; also 26 dB, omni
Max SPL132 dB SPL, cardioid, 0.5% THD; also 133 dB SPL, omni
Signal-to-noise ratio78 dB, cardioid; re 94 dB SPL, A-weighted; also 80 dB, omni
Output impedance35 ohm, CMC 6 on 48 V phantom; also 25 ohm, on 12 V phantomp. 7
Rated load impedance600 ohm, minimum recommended
Rated frequency range40 Hz to 20 kHz, cardioid; also [20, 20000], omni. Omni extends beyond 40 kHz with the CMC 6 xt amplifier.p. 20
Poweringphantom, 12 V or 48 V (CMC 6, automatic switchover)p. 7
Current draw4 mA, 48 V phantom; also 8 mA, 12 V phantom
ConnectorXLR-3 male. Not stated by the manufacturer: On the CMC amplifier; the guide shows the XLR output but does not list it as a spec.p. 2
Weight66 g. "65 - 68 g, depending on type": the CMC amplifier; the capsule's weight is not stated.p. 7
Dimensions116 × 20 mm. CMC amplifier: length 116 mm (incl. 3 mm capsule thread) × diameter 20 mm. The capsule adds to the length (not stated).
AmplifierCMC 6 (CMC 6U / 6Uxt); low-cut (-3 dB) at 20 Hz
Maximum output voltage1 V (at 1 kHz into 1 kOhm)
PolarityPositive pressure on the 0° axis gives a positive voltage on pin 2
FinishMatte grey (g) or nickel (ni)
CharacterSlightly brighter than the MK 2H (omni) or MK 4 (cardioid)p. 17

Documents

Copies kept by Mic Archive, because manufacturers move and drop their documents. Each is © Schoeps, unchanged, with its original address.

Product page on schoeps.de

Recommended for

Instruments whose sources name this mic, or an earlier version or variant of it.

Other mics