Mic Archive
Audix D2
Photo: Audix, from its spec sheet, p. 1.

Audix

Audix D2

Dynamic, hypercardioid, compact drum and instrument mic (rack toms, congas, cabinets, brass)

Approximate Some readings for this mic are uncertain; see the graphs.

Type
Dynamic
Pattern
Hypercardioid
Sensitivity
−58.4 dBV/Pa
Max SPL
144 dB SPL
Impedance
280 Ω
Rated range
68 – 18k Hz

Frequency response

Angle
Distance

Frequency response: from the spec sheet (Recording Hacks copy), p. 2. Titled "FREQUENCY / POLARS"; "dBm", relative. Distance, room and smoothing not stated.

Dashed: outside the rated range, or simulated (other angles and distances). Hover or tap the graphs for values.

Polar pattern

Polar pattern: from the spec sheet (Recording Hacks copy), p. 2. Two full-circle plots ("Lo": 125 Hz to 1 kHz; "Hi": 2 to 16 kHz), "dBSPL" from 0 to -36 dB, each frequency drawn at its own level. Measuring conditions not stated. Approximate reading error up to about 1 dB.

Compare with other mics

All specs

From the spec sheet
CapsuleVLM Type B (Very Low Mass diaphragm). "Capsule Technology: VLM Type B"; page 1: "VLM™ (Very Low Mass) diaphragm".p. 2
Sensitivity−58.4 dBV/Pa (1.2 mV/Pa), 1 kHz. "1.2 mV / Pa @ 1k"; converted (20 log10 0.0012).
Max SPL144 dB SPL, "≥144 dB"; distortion not stated
Output impedance280 ohm, nominal, 1 kHz; also 250 ohm, 2010 cut sheet. "280 ohms". The 2010 cut sheet gives 250 ohms.
Rated frequency range68 Hz to 18 kHz; also [80, 18000], 2010 cut sheet. "68 Hz - 18 kHz". The 2010 cut sheet says "80 Hz - 18 kHz".
Poweringnone. "Power Requirements: None"; not affected by phantom power.
ConnectorXLR-3 male, gold-plated. "3-pin XLRm"; page 1: "gold plated XLR connector". The 2010 sheet says Switchcraft male XLR.
Weight128 g. "128 g / 4.5 oz".
Dimensions39 × 100 mm. Widest diameter × length: "21.5 mm in diameter at the base, 39 mm in diameter at the widest point and 100 mm in length".
Finishblack anodised (hard coat), machined aluminium body. "Black Hard Coat"; page 1: "precision machined aluminum body, durable black anodized finish".
Supplied accessoriesDCLIP heavy-duty snap-on clip; P1 carrying pouch. "Supplied accessories".p. 1
Off-axis rejection>30 dBp. 2
GrilleDent-resistant steel meshp. 1
DesignTransformerless, low impedance, balanced output
Placement (Audix)Drums: bottom of the grille 1-2 inches above the head, pointed at the centre; pull back to the rim for more ring, closer for more attack. Cabinets: within 1-2 inches of the grille cloth. Horns: within 1-2 inches of the bell.p. 2

Documents

Copies kept by Mic Archive, because manufacturers move and drop their documents. Each is © Audix, unchanged, with its original address.

Product page on audixusa.comRecording Hacks

Recommended for

Instruments whose sources name this mic, or an earlier version or variant of it.

Other mics